ASL INTERCOM BS 216 Manuel d'utilisateur télécharger pdf (Page 14)

Linking two ore more TS 120

Master Stations

Master Stations can be inter linked

via the D9 serial link connectors on

the rear panel.Linking for instance

2 stations, a 24-channel cue light

system is obtained.Up to 12 Master

Stations can be linked, thus offering

a 144-channel Cue Light system.For

any multi-channel system,only one

TS 99 Preset Control is needed.

TS 10 CUE LIGHT RECEIVER

TS 99 CUE LIGHT PRESET CONTROL

CUE LIGHT SYSTEM INTRODUCTION

The ASL Cue Light system consist of one or more 12-channel Master Stations, the required number of

Cue Light Receivers and a Preset Control unit (optional).The connection between Master Stations and

Receivers is made by standard microphone cable (two conductors and one shield) with XLR-3

connectors.

TS 120 CUE LIGHT MASTER STATION

This 19"/2U unit contains 12 cue light channels,with an 'All selected channels GO' and a 'Clear' push button. Each

channel of the TS 120 has an ATTN (attention) push button and a GO push button, accompanied by a bi-colour LED that

is red illuminated in ATTN mode and green in GO mode.The unit may be connected to mains voltages from 100 - 240 V

AC (auto select) 50/60 Hz.

THEATER SERIES

TS 10 CUE LIGHT RECEIVER

This ABS box has a large red LED

indicating the ATTN (attention)

signal and a large green LED

indicating the GO signal.

TS 99 CUE LIGHT PRESET CONTROL

The TS 99 Preset Control is powered by the TS 120 via the interconnecting

cable. It can hold a maximum of 100 presets, stored in non volatile memory.

Each preset is a selection out of maximum 144 channels, obtained when

twelve TS 120 master stations are linked (see above ‘Linking two ore more TS

120 Master Stations’).Each preset has its page number,which is selected and

displayed in the LED screen by using the 'up' and 'down' push buttons.

TS 120 CUE LIGHT MASTER STATION

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

ASL INTERCOM BS 216 Manuel d'utilisateur Page 14