ASL INTERCOM BS 216 Manuel d'utilisateur Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 11
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
User Manual BS 216 / Issue 1 © 1998 ASL Intercom, Utrecht, Holland.
2
WARNING
This appliance must be earthed
4.0 MAINS POWER
The BS 216 may be connected to the mains power outlet The wires in this mains lead are colour coded in
to which other audio equipment is connected. The outlet accordance with the following code:
should have a clean earth. Avoid using mains power
outlets which also power dimmer controlled lighting green and yellow Earth / safety ground
equipment. blue Neutral
The used AC power source can be anything from 100 -
240 V AC, 50/60 Hz. There is no need to adjust the unit to As the colours of the wires in the mains lead may not
the used mains voltage. correspond with the coloured markings identifying the
The power cord supplied with this unit carries the following - The wire which is coloured green-and-yellow must be
information label: connected to the terminal in the plug which is marked
IMPORTANT
brown Live
terminals in your plug, proceed as follows:
with the letter "E", or by the earth symbol which is or
coloured green.
- The wire which is coloured blue must be connected to
the terminal which is marked with the letter "N" or
coloured black.
- The wire which is coloured brown must be connected
to the terminal which is marked with the letter "L" or
coloured red.
Those units that are supplied to the North American
market will have an integral moulded 3 pin connector
which is provided to satisfy required local standards.
4.1 SAFETY EARTHING
The green-and-yellow wire of the mains cord must always
be connected to the electrical installation safety earth or
ground. It is essential for personal safety as well for proper
operation of the BS 216 and the other connected stations.
This wire is internally connected to all exposed metal
surfaces and any rack framework into which this unit might
be mounted is assumed to be connected to the same
grounding circuit.
4.2 POWERING UP
Powering up procedure:
- Make sure that the red power switch on the left side of
the front panel is OFF.
- Connect the power cord to the rear of the station.
- Plug the other end of the power cord into a
PROPERLY GROUNDED outlet.
- Turn on the power with the red button, the green power
LED will go on, indicating the station is active.
Vue de la page 2
1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire